GCD commands

Select a GCD and right-click in the GCDs pane to see the GCDs command menu. Use the Shift and Ctrl keys to select multiple GCDs of the same type for bulk editing. Commands in the menu apply to the highlighted GCDs. Commands unavailable for the highlighted GCDs are disabled.

The GCDs command menu includes the following commands:

• Edit: Opens the Geometric Cost Driver Editor for the highlighted GCDs.

• Remove: Deletes the selected virtual weld.

• Edit tolerances: Opens the Tolerance Editor for the highlighted GCDs. If no GCD is highlighted, this command is unavailable.

• Alternatively, you can edit tolerance and roughness values directly in the GCD Properties table.

• Auto-merge: Auto-merges an unmerged ComboVoid GCD. Available only for ComboVoid GCDs that have been unmerged using the Unmerge command below.

• Unmerge: Unmerges a SimpleHole or a MultiStepHole GCD from a Void GCD in a ComboVoid GCD.