Ejector Plates Surface Area Calculation

Ejector Plates Surface Area = ((Mold Base Length * (Mold Base Width - Ejector Plates Width Reduction)) + (Mold Base Length * Ejector Plate Height) + (Mold Base Width * Ejector Plate Height)) * 2

  • Mold Base Length: This is specified by the Mold Base Size – Length setup option.

  • Mold Base Width: This is specified by the Mold Base Size – Width setup option.

  • Ejector Plates Width Reduction: This is specified by the cmEjectorPlatesWidthReduction cost model variable (152.4 mm in starting point Digital Factories).

  • Ejector Plate Height: This is specified by the cmEjectorPlateThickness cost model variable (25.4 mm in starting point Digital Factories).