Develop Solder Mask Setup Option

The Strip Solder Mask > Develop Solder Mask node of the Process Options Editor provides the setup option Number of Panels Loaded to the Develop Solder Mask Conveyor Simultaneously.

Number of Panels Loaded to the Develop Solder Mask Conveyor Simultaneously

By default in starting point Digital Factories, aPriori assumes that panels travel along the Develop Solder Mask conveyor in a single file. Administrators can customize the default with the cost model variable defaultNumberPanelsLoadedDevelopSolderMaskConveyor (1 in starting point Digital Factories), which specifies the number of panels arranged next to each other across the width of the conveyor.

With the setup option Number of Panels Loaded to the Develop Solder Mask Conveyor Simultaneously (defined by the Strip Solder Mask > Develop Solder Mask node of the Process Options Editor), users can override the default on a per-part basis.

Users must specify a value that is no greater than the maximum number of panels that can fit across the conveyor of the Develop Solder Mask machine with the largest Usable Width, assuming:

• Panel shortest dimension is aligned with conveyor width.

• Panels are separated by the distance specified by the cost model variable defaultConveyorPanelSpacingWidth (100mm in starting point Digital Factories).

This setup option affects machine selection: a machine is feasible only if its Usable Width can accommodate the specified number of panels. This setup option also affects per-part cycle time.