Skip to content

Plastic Molding

Geometry or Cost Engine Changes that Could Impact Configured Digital Factories

The following changes might impact costing, even for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Bug Fixes or Small Improvements to Prior Cost Model Versions

The following changes might impact costing for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Cost Model Changes that Do Not Affect Configured Digital Factories

The following changes do not affect costings with Digital Factories that use earlier cost model versions. The changes are available only in the latest cost model version.

  • Structural Foam Molding Machine Table (Impacts Machine Selection): This release corrects a problem in the machine table for Structural Foam Molding. Previously, the values for the properties Tie Bar Distance, Hor and Tie Bar Distance, Vert were swapped. This could result in machine selection failure and therefore unsuccessful costing. In this release, the machine table has been updated with the correct values for these properties.