Skip to content

Machining

Changes that Could Impact Configured Digital Factories

The following changes might impact costing, even for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Bug Fixes or Small Improvements to Prior Cost Model Versions

The following changes might impact costing for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Cost Model Changes that don't Affect Configured Digital Factories

The following changes do not affect costings with Digital Factories that use earlier cost model versions. The changes are available only in the latest cost model version.

  • Bar Feed Lathe (impacts batch setup time): This release improves the batch setup time calculation for Bar Feed Lathe processes, so that these setup time estimates are now greater than the batch setup times for conventional lathes.
  • Tool Length-to-Diameter Ratio (impacts design guidance): Design guidance for Machining no longer includes the issue type High Milling L/D Ratio, since the information provided by this type of guidance is largely duplicated by Long Tool Reach guidance. In addition, the issue type Side Milling L/D is now called Side Milling L/D Ratio Exceeded.