Skip to content

Plastic Molding

Geometry or Cost Engine Changes that Could Impact Configured Digital Factories

The following changes might impact costing, even for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Bug Fixes or Small Improvements to Prior Cost Model Versions

The following changes might impact costing for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Cost Model Changes that Do Not Affect Configured Digital Factories

The following changes do not affect costings with Digital Factories that use earlier cost model versions. The changes are available only in the latest cost model version (CMV300).

  • DFM Issue Count (impacts design guidance only): this release resolves an issue where the DFM Issue count was aggregated incorrectly for some Injection Molded parts. Specifically, parts with the issue high blind hole length-to-diameter ratio displayed mismatched totals between the overall issue count and the sum of each category. Totals now aggregate correctly.