Skip to content

Plastic Molding

Geometry or Cost Engine Changes that Could Impact Configured Digital Factories

The following changes might impact costing, even for Digital Factories that use earlier cost model versions.

  • Material Specified in Bulk Costing & Analysis Dialog Now Applied During GCD Extraction (can impact flow appraisal): This release resolves an issue where the material specified in the Bulk Costing & Analysis dialog was not correctly applied during GCD extraction, causing material-dependent GCDs to be computed incorrectly.

    As a result of this change, the flow appraisal may change compared to the previous release, which can affect tooling cost, machine selection, and cycle time.

  • Note:

      Bulk Costing via spreadsheet input was **not** affected by this issue, and its results will not change compared to the previous release.

Bug Fixes or Small Improvements to Prior Cost Model Versions

The following changes might impact costing for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Cost Model Changes that Do Not Affect Configured Digital Factories

The following changes do not affect costings with Digital Factories that use earlier cost model versions. The changes are available only in the latest cost model version.

  • NO IMPACT