Skip to content

Bar & Tube

Geometry or Cost Engine Changes that Could Impact Configured Digital Factories

The following changes might impact costing, even for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Small Improvements to Prior Cost Model Versions

The following changes might impact costing for Digital Factories that use earlier cost model versions.

  • NO IMPACT

Cost Model Changes that Do Not Affect Configured Digital Factories

The following changes do not affect costings with Digital Factories that use earlier cost model versions. The changes are available only in the latest cost model version.

  • Tube Laser EndLaserCutting Operation (can impact cycle time): This release corrects an error in the cycle time estimate for cutting the ends of tube stocks. As a result of this change, cutting times may increase compared to the previous release. In most cases the increase will be a few seconds or less.